Gregory T Reid
Comentado en los Estados Unidos el 21 de marzo de 2024
I'm surprised at how well this works, especially given its cheap price. I've ordered two of them, and they both completely turn off when off. There is no leakage whatsoever from the on/off valve. I used a little bit of "T plus 2" thread sealant on the 8mm hose junctions (not sure if it was really necessary) but am happy to report that the input and output quick-connect junctions are also completely leak free.I have the rest of my air system (using 8mm tubing and about a dozen of the quick-connect junctions) also completely leak-free, which means that I can leave my compressor turned on and not have to worry about it "leaking down" through the night and turning itself on to re-pressurize. In fact I can leave it for weeks at a time without any leakage.Anyway, I'm very happy with the quality and effectiveness of these foot pedals, and would definitely order another if needed.
Denis Briand
Comentado en Canadá el 12 de abril de 2023
Pas installé encore
Joe Luke
Comentado en Canadá el 9 de marzo de 2022
Works as promised
Michael Mahoney
Comentado en los Estados Unidos el 16 de septiembre de 2019
If you are looking to use this switch with multiple pieces of air equipment , you will need to make some adjustments as the inlet/outlet ports are close together, If this switch is being used for one piece of equipment it should be plumbed as expected for this style of switch. A couple swivel adapters and all is good to make it a "portable" unit. I wanted this for a DIY hand held planishing hammer, and with the air adjustable swivel it works perfect and mobile.
Customer
Comentado en los Estados Unidos el 20 de enero de 2018
In/out ports are way too close together if you're going to use QD's on them. I want to be able to use this for more than just one item, so I installed QD's on it. I had to use an elbow on the 'in' port in order to get the spacing needed to connect to those. Without the elbow, there's NO way you'll be able to use the QD's.Markings for the 'in' and 'out' ports are mostly hidden by the metal body. Would have been MUCH better if the marks were ABOVE the ports, not under them.Performed a function test on the valve once QD's were attache and it works as it should. Won't know how it holds up over time until I give it more use. Right now I plan to use this on an air assisted bottle jack (20 ton) that will be the main part of a forge press.