No hay artículos en el carro
No hay artículos en el carroCareFreeWoot
Comentado en los Estados Unidos el 19 de septiembre de 2024
This is a outdated product that does not do many things. I managed to get four cameras to take picture one by one, and could not get further. I searched online material, and it seems that is all this product is capable of. Contacted their customer support but very soon get ditched after got only a couple of responses.Don't waste your money on this.
Eduardo89
Comentado en México el 7 de abril de 2023
Excelent product, arrived very fast and in good conditions
Jean Oberson
Comentado en Francia el 30 de septiembre de 2022
L'installation est laborieuse et mystérieuse. Finalement, après les avoir connecté au module arducam, j'ai grillé deux cams qui fonctionnaient bien auparavant. Méfiez vous. C'est ma première déception raspberry après une vingtaine d'expériences.
Lynn Ericksen
Comentado en los Estados Unidos el 29 de marzo de 2021
After trying to figure out on programming this adapter and getting it to work its been nice to have something that would work using 4 cameras at the sametime! Definitely going to buy another somewhere in the future!
Customer
Comentado en Canadá el 1 de noviembre de 2020
I have been struggling with this for days. I used 2 2.1 cameras, one for day and one for night. Each time I switch it freezes and takes minutes to actually switch and work without freezing.I tried their support forum and its basically dead. I got one response in days. This is expensive, save your money and buy another pi, you will be happier and have less headaches. I don't know if my part is defective or not but with the lack of support its as good as garbage.
Cristiano Cardarelli
After a relatively straightforward installation, I started noticing serious errors. First, the board did not work and it was not read by the Raspberry Pi. I wasted many hours through blogs full of complaints of users not able to use it, and I now understand why:Otherwise as shown in its advertisement on Amazon and on the Arducam website, this board is not good for videos. In fact, it makes such that cameras take quick pictures and not videos, and kind of stitch them together, to give this feel that a continuous stream is being initiated.The cameras cannot run simultaneously. Again, not fully explained when reading the description on Amazon and on the Arducam website, and is only readable on the paper documentation that comes with the product, once purchased.When the adapter is reported as faulty by the users, the usual response of the manufacturer's technical team is to replace the cable, as faulty. This is incorrect and misstated, as what happens in fact, is that the board absorbs too much power and GPU memory from the board and it causes it to "freeze". I could test this as, whereas the script "sudo ./init_camera.sh" was returning a "camera not found error", when instead I reduced the number of cameras from three to 2, updating the boot file too, then, no matter the ports chosen. The adapter would be indeed recognised, and the images produced.The conclusion is that this board has been badly engineered, incorrectly explained and supported, and creatively advertised and that it is ultimately, a very bad product.
Productos recomendados
Mex $2,177.81
Mex $ 1,045 .00 Mex $1,045.00