No hay artículos en el carro
No hay artículos en el carro Los soportes de elevación A-premium son una opción ideal para reemplazar tus soportes de elevación rotos. Todos los soportes de elevación cumplen o superan las especificaciones OEM. Debido al alto estándar de fabricación, viene con un año de garantía de calidad.
Compatible con modelos Chevrolet:
Corvette 2014-2017 V8 6.2L Coupe
Corvette 2016 V8 6.2L Targa
Corvette 2014-2017 V8 6.2L Convertible
Longitud extendida (pulgadas): 16.1 pulgadas.
Longitud comprimida (pulgadas): 9.33 pulgadas.
Longitud del trazo: 6.77 pulgadas.
Diámetro del eje (mm): 8 mm
Diámetro del cuerpo (mm): 18 mm
Conexión del eje (mm): 10 mm
Conexión del cuerpo (mm): 10 mm
Número OEM: 22772878, 7023, PM3367.
Ubicación: Capucha frontal
Cantidad vendida: un juego de dos piezas
Diego L Betancourt
Comentado en los Estados Unidos el 26 de marzo de 2025
These hood struts are superb and extremely cost effective! They hold the hood at any level you choose without it moving. Total time to install was about 1/2 hour. The right side one was a bit more difficult because my Corvette it has an aftermarket supercharger an there was a hose veru close to the mounting stud and I had to get it from under the car.
Glenn K.
Comentado en los Estados Unidos el 21 de marzo de 2025
Works as good as the OEM ones.
John Sheakley
Comentado en los Estados Unidos el 22 de julio de 2024
Worked great and a lot cheaper than factory
Eagl3
Comentado en los Estados Unidos el 12 de marzo de 2024
ez installation. Same connection points as OEM. Works great
Cindy Hurst
Comentado en los Estados Unidos el 31 de octubre de 2022
This fit perfectly on my 2016 C7 Corvette Stingray. The drivers side takes a few minutes, even with a learning curve. The top clip on the passenger side is just as easy but the lower clip is almost completely obscurred by air induction parts. A simple tip. Unclip the passenger side top clip first to allow enough room for your arm to reach the bottom clip. The bottom clip must be undone completely by feel so practice outside the car first. Then use a very small regular screwdriver to wedge under the clip and remove the old strut. Very easily clip in the new strut bottom first. Do NOT allow the unteathered top clip to fall below hinge level though and become stuck too low during this step. Otherwise you will repeat the first step. Sigh... In all though, a very simple installation!
Productos recomendados
Mex $523.99
Mex $ 251 .00 Mex $251.00
Mex $1,473.03
Mex $ 618 .00 Mex $618.00
Mex $7,018.59
Mex $ 1,881 .00 Mex $1,881.00
Mex $5,020.65
Mex $ 1,881 .00 Mex $1,881.00
Mex $3,098.96
Mex $ 1,363 .00 Mex $1,363.00
Mex $2,083.88
Mex $ 1,021 .00 Mex $1,021.00
Mex $4,169.44
Mex $ 1,881 .00 Mex $1,881.00