No hay artículos en el carro
No hay artículos en el carroMás información del producto
SuperSpaceshipX
Comentado en los Estados Unidos el 25 de mayo de 2024
This product worked well for me on several occasions so far removing power connectors on my Gameboy SP that was was modding to USB-C.The ground legs are notoriously difficult to keep solder molten and remove.I was able to use the low-melt which stays molten for quite long I must say to remove the legs and pins all at once!It cleans up easily too with solder wick or suction which is nice.The only Negative that it's a bit expensive for what you get but it does work well, so I'd buy more once I use up this batch.oddly some components I found it difficult to get the low-melt to attach to initially, it helped to use flux though. not sure if anything can be improved upon for it but just wanted to mention it.
Generic Nerd
Comentado en los Estados Unidos el 12 de diciembre de 2024
After dipping my toes into the Nintendo modding world, I decided to rig up my old GameCube with a battery holder to help with replacement of the internal soldered in CR2023 battery and replace the stock orange LED on the unit. That being said the solder works like butter. I went in low and slow with a little flux on the pins and my iron at 350. The solder melted nearly immediately amalgamation perfectly with the old solder. Two clicks of the solder sucker and there was nothing left to hold in the LED, two more and the internal battery was out. The board also cleaned up super nice with solder wick after. See my photo for the aftermath of the LED install.
Tyrus
Comentado en Australia el 18 de agosto de 2023
Thank You A+++++
Graham H.
Comentado en Australia el 14 de octubre de 2023
really great for getting components off the PCB even the unleaded solder which can be a real pain will purchase again
Al Winney
Comentado en Canadá el 25 de abril de 2021
I've been fixing radios for 40 years and when the new surface-mounted components started to immerge it became an issue to remove large IC. I was skeptical at first till I had to remove a 40 pin IC from the radio and I didn't want to brick a customer's radio. I found this alloy that actually works fantastic for large IC removal. For modern day electronics, this is the best it makes it so easy to remove large IC's from a circuit board
Productos recomendados
Mex $208.78
Mex $ 106 .00 Mex $106.00
Mex $262.80
Mex $ 152 .00 Mex $152.00
Mex $1,478.16
Mex $ 709 .00 Mex $709.00