No hay artículos en el carro
No hay artículos en el carroCustomer
Comentado en los Estados Unidos el 12 de marzo de 2025
Great tiny solution for converting 120 VAC to 12 Vdc.Only problem I had was the labeling on the terminal strip was not very consise which led me to connect the negative lead of my circuit to the "Gnd" terminal instead of the - terminal.The "Gnd" terminal was earth ground for the AC input and not common to the DC ground.Once connected correctly, it worked great and runs cool with its very good heat sinking.
clipper
Comentado en los Estados Unidos el 15 de febrero de 2025
Bought this for prototyping a WLED project. The final project will consist of 5-6 60' runs of 24v leds, so wanted something a bit overpowered for the first run to measure current consumption before picking up a power supply with a higher rating.As the majority of these power supplies are shipped with the switch in 220v, double check it before hooking it up. It's lightweight, not too large, outputs a relatively stable 24 volts (23.9-24.2 on my fluke meter), functions perfect (once again, for my use). The power supplied is pretty clean, although i did add ferrite beads as i do with most power supplies.Overall, it's a good value for a decent power supply.
MikeB
Comentado en los Estados Unidos el 24 de enero de 2025
It works and has not caused a fire yet
Customer
Comentado en los Estados Unidos el 4 de julio de 2024
thanks
stephen Lynch
Comentado en los Estados Unidos el 3 de junio de 2024
I consume copious amounts of these power supplies to power LED Signage, solid state relay control voltage, and for Making My own device charging stations.They're about the size of 2 packs of playing cards stacked. They'll put out 10 amps / 50 watts.that's enough to power 300 led pixels, 3 16ft ws2812 led strips, or power 3-4 raspberry pi 5 devices.They're great power supplies, and have a little adjustment pot, so you can dial it in to exactly the voltage you need, and they'll stay there!
Productos recomendados