No hay artículos en el carro
No hay artículos en el carroRecklessBoon
Comentado en los Estados Unidos el 2 de enero de 2025
I got this so that I would be able to have two magnetic plates on my resin printer. That small change made it much easier to work with since I could take a print off with the plate, put it in the cleaner, and put the second plate on all at once with the same pair of gloves. This allowed me to ensure the outside of my printer and cleaner are almost definitely resin free and allows me to do later parts without having to stop and put on a pair of gloves just to remove the lid. It also allows me to start a second print while the first is cleaning. The steel plate feels springy and well made. The magnet seems to be just as good as the other one I have as well. Plenty of holding strength. I very much recommend this product.
Chen
Comentado en Singapur el 16 de marzo de 2024
popped this one right off after I applied correct resin settings, previously it did not work for me but it turns out to be my beginner error
けんしん
Comentado en Japón el 2 de diciembre de 2024
ビルドプレートを洗浄する時や、成形物がビルドプレートから剥がれ辛い時に、凄く助かります。プレートへの密着性も問題ないです。
Carlos García Aguilar
Comentado en México el 20 de octubre de 2024
es muy fácil de usar y de desprender las piezas en la placa sin necesidad de usar la espátula
Ryan McCarty
Comentado en Canadá el 20 de octubre de 2024
No more having to remove the entire bed after a print. No more needing to chisel the pieces off. No more running a heat gun on the plate to loosen those stubborn pieces. No more needing to recalibrate the bed because you used so much elbow grease to get the pieces off that you nudged the arm out of alignment. Now, I pop the steel plate off the magnet, flex it, and the pieces peel right off without even needing to use a scrapper. A must-have for anyone using a resin 3D printer.
カスタマー
Comentado en Japón el 3 de enero de 2024
・3Dプリンター用のビルドプレート。・マグネットによって着脱する。プリント完了後はこれを持ち上げるだけで造形物が剥がれるため作業効率は一気に向上する。・表面を脱脂し適切に設定すれば問題なく定着する。定着しない、弱い場合はレベリングミスか温度不足が考えられるので見直し推奨。
Yared Sánchez
Comentado en México el 20 de agosto de 2023
Hasta el momento se ve bien esperare a usarla
Manuel A.
Comentado en México el 30 de septiembre de 2023
No me gustó, hice una pieza muy pequeño y si funcionó, pero cuando puse una impresión que requería mas tiempo la pieza terminaba despegándose, como al principio se resbala y finalmente se despega, eché a perder casi medio litro de recina, ya mejor la tiré a la basura, no sirve. No la recomiendo.
Productos recomendados