No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Material de goma y no se rompe fácilmente
Material de aleación de zinc
Varios colores de borlas
Stephanie N Gates
Comentado en los Estados Unidos el 29 de diciembre de 2023
These sublimated nicely. Easy to use. They came with all the hardware needed and cute little tassles. I liked how they came out. I'd use them again.
Amy
Comentado en los Estados Unidos el 28 de diciembre de 2023
They are nice but the tassels are hard to connect.
Leea H.
Comentado en los Estados Unidos el 30 de marzo de 2022
Honestly I messed up my first one because I left the keyring on it and the nylon melted. I did it once and learned my lesson quickly. I use a-sub paper, an epson et-2720, with Printers jack sublimation ink. I use a cricut easypress2 set to 370°F for 50 seconds on each side. These are a hit with my customers and they LOVE that I can personalize without vinyl. I usually press multiple at the same time and haven't had any other issues. dont forget blowout paper on both your heat mat and to protect the easy press. ink blowout will happen especially is you print way bigger than the keyfobs. Happy subbin yall.
Jaydeee
Comentado en los Estados Unidos el 8 de diciembre de 2022
These are great sublimation keychains! They work just as I intended and will purchase again if they sell well!
Sary
Comentado en los Estados Unidos el 12 de septiembre de 2022
Definitely vendor needs to add temp and pressure instructions. I did mines at 370 for 90sec/side. These came out great, but needed to figure out on my own. I created my designs to he a little bigger than the wristband. Need to remove the ring prior to pressing, med/low pressure, tape it onto your design towards the long way. I use a pressing foam to alleviate the pressure from the ring loop as this material could easily melt. Press one side, then flip and press the other side.
Productos recomendados
Mex $153.00
Mex $ 90 .00 Mex $90.00